well, no, they aren't glued together. i guess it's the same as with the jornadas.. don't use a screwdriver, just your hands. the trick is going in the right direction. also, did you remove all screws?
anyway 8th step describes it in details:
"The sides an d front o f the k eyboard
(top half
) w ere g rasped a s show n in the p ictu re above — thum b
an d little finger o n the lower h alf and the o ther three fingers o n the upper h alf o f the case.
Usin g the thum bs to h o ld dow n w ith some force o n the lower h alf o f the case, the k eyboard half w as
p ressed in slightly an d the to p half o f the case m oved u p w ith the o ther three fingers.
(It was a lot
easier than it sounds.
) It d idn’t take a lot o f force to d o this — I h a d to b e careful n o t to o v erd o it!
There a re some c a tch es on the m otherboard that this releases.
A slightly c lick w as h eard an d the top h alf
(keyboard side
) slid forward
(up , in the p o sition its in as
shown in the p icture , above ."
(sorry for the lot of spaces, it got copied out of the pdf like this and i don't have the patience now to remove them
)
Edited by cmonex 2006-07-04 7:37 PM