|
H/PC Newbie Posts: | 18 |
Location: | United Kingdom | Status: | |
| Hi, i need some help and advise, i got a sharp mobilon hc4600 and an aironet 340 card, ive synced the froms from my laptop, but i cant get the card to work properly, the light on the card comes on and eventualy the green light goes off, is there a wep utility for wince 2.0, ive have installed the mips20e.e driver can anybody help at all any advice would be handy,john | |
| |
Global Moderator H/PC Guru Posts: | 7,188 |
Location: | USA | Status: | |
| Hmmm, don't you have to install the network service pack on CE2.0 machines first to connect? I don't remember? | |
| |
Administrator H/PC Oracle Posts: | 17,979 |
Location: | United Kingdom | Status: | |
| Yes, it requires my NSP first to enable the ethernet stack. | |
| |
H/PC Newbie Posts: | 18 |
Location: | United Kingdom | Status: | |
| ok , i shall give the nsp stack a try, any ideas about wep driver at all or does this not support wep encrption with aironet on wince2.0.,john | |
| |
H/PC Newbie Posts: | 18 |
Location: | United Kingdom | Status: | |
| Ok ive managed to get the aironet card working but after a few mins it say cannot get dhcp, how would i set this card up on my home network as encrption set on the router which i also use my normal laptop and my son uses his,so i dont whant to disable my wep, so the question is is there a wep utiliy under wince 2.0 | |
|
Seconds to generate: 0.144 - Cached queries : 62 - Executed queries : 9
| | |
|