Been going a few rounds on this, but not sure where to go on it. I have my VM
(Win95
) going, I have a serial port going. I have H/PC 1.1 installed. When I go to the PC Link on the HP 320LX it looks like its starting on the PC, but then keeps saying its retrying on the HP.
(The connection times out after 5 sec
)
I have checked the port settings on the VM, I've tried tweaking different combos of flow control, nothing. I left it at 19200/8N1. Trying to figure out what if anything I am missing.
I tried a Palm III on the same VM for sanity. That seems to Hot Sync just fine, goes all the way though. The best I can guess is that A
) The H/PC connection *needs* the Hardware flow control and B
) my USB-Serial adapter is not cutting it there. I may try and switch that up.
Any ideas on why it would start but not go forward? Is flow control needed? Is there another way to talk to this thing for sanity? At this rate I may be playing with serial software for it sooner than later.