Velo 1 and xp

Hi, when i try to connect my velo 1 with windows ce 1 to my windows xp computer with service pack 2 using activsync i get told its not compatible with the pda or something so u have downloaded H/PC explorer but that doesnt work because i have service pack 2
Any ideas?
Thanks.
Chris

Try H/PC Explorer in the support section.

I couldnt find anything in there about xp sp2

It has nothing to do with SP2, it is Windows XP. There are guides on getting it working under XP.

My velo now syas "Status: physical layer established" but H/PC explorer still won't connect please help me.
Thanks, Chris

this is the message i get when instaling.

Help you do what, you've not given me anything to go on?
Anyway, all the information you need is in CESDS0002

Edit: Double post rule...

That says Windows NT SP2, you're using Windows XP Remember this software is 9.5 years old now.

I followed all the instructions on CESDS0002 and my Velo just says physical layer established and H/PC does nothing, and, Windows XP is built on NT technology.
Chris

Did you follow footnote 3?

I just followed footnote 3 then on my Velo i dont connect but i get a error messgae saying: cannot start communications with the desktop computer. Remote networking could not start due to critical error (error 628).

Please reconnect the HPC. if the proplem persists, restart the HPC using the instructions provided by the manufacturer.


Chris

OK.

Have you fiddled with the port speeds on the H/PC or XP? If so, undo that.
Please reboot your computer, disconnect from the Internet, kill off your firewall and anti-virus, and tray services which make use of serial ports, soft reset the H/PC and try it again.

Thank you very very much.
Chris

Did it connect alright?

yes it did thanks, is there a way of using internet explorer on my Velo if its connected to my pc via serial?
Thanks.

: http://www.hpcfactor.com/support/cesd/c/0018.asp ... Please look into going through the site better ...