hydroking - 2005-02-24 7:12 AM
I use a D-Link DCF-660W CF NIC is my Intermec 6651 (MIPS TX3922), and it works great; but I have installed Ministumbler and it does not see the card.
The 660W uses the Prism2 chip-set, and I know others have gotten Ministumbler to work with this card, so I think it is a driver issue. The Intermec will only load the original ver 1.0 d-link driver and version 1.1 of the config utility through Activesync. I haven't tried manually pulling a later driver out of a more recent d-link exe. Before I try, I wanted to see if anyone had any suggestions regarding newer d-link drivers, or others (Intersil, Orinoco, or Senao)?
Thanx
Easiest to just plunk in the driver cab files and install them on your HPC.
