|
| Hi. I get "Unable to open an initial console" when booting 720degrees.
I've tried: sarge-r2, debian-sarge-stable. I've tried untaring with and without the p flag. Yes, everything is in the right place and I'm using the right kernel, I've checked... Lots of times :-)
Any ideas?
I'm pretty much at a loss. I'm just gonna try etch base with 2.6 to see if that works... Though I'm under the impression that wifi doesn't work with that? (Is that right? I'm not sure...)
Thanks. | |
| |
H/PC Elder Posts: | 2,294 |
Location: | Sunny California | Status: | |
| Just go to forums.720degrees.net, and read some of the newbie threads. If you post there, I will see your problem sooner.
Wifi works with 2.6. Actually, everything works on 2.6 but sound, and twice as good as it does on 2.4. | |
| |
| I found the problem. I was untaring from a mac. I think it's mknod is different from linuxes mknod. I did the whole thing from my linux pc and it worked fine. Thanks! | |
| |
H/PC Elder Posts: | 2,294 |
Location: | Sunny California | Status: | |
| Why would you need mknod? | |
|
Seconds to generate: 0.125 - Cached queries : 59 - Executed queries : 9
| | |
|