|
H/PC Philosopher Posts: | 471 |
Location: | Italy | Status: | |
| I'd like to use Planmaker on Sigmarion III but when I launch it the screen mees up and eve if functional you have to soft reset.
Do I Have to upgrade some dlls to run Planmaker on Sig3?
Execcheck tells me everything is fine. Can I tell with Dependencies walker if Planmaker miss of some dlls?
P.S.: These days I downgraded my NEC 900c to CE Net 4.2 from cmonex 2.0 and with Planmaker had the same issue. Maybe i need some dlls used in cmonex rom. | |
| |
Global Moderator H/PC Guru Posts: | 7,188 |
Location: | USA | Status: | |
| I think you have the wrong version of PlanMaker. Are you using the HPC2000 version? If not...which one? | |
| |
H/PC Philosopher Posts: | 471 |
Location: | Italy | Status: | |
| My release is: Planmaker 2008 for PocketPcs (rev 503) | |
| |
H/PC Sensei Posts: | 1,169 |
Location: | Russia | Status: | |
| Why don't you try HPC2000 or Windows CE.Net version? | |
| |
Global Moderator H/PC Guru Posts: | 7,188 |
Location: | USA | Status: | |
| Use Softmaker Office 2006...it works fine... | |
| |
H/PC Philosopher Posts: | 471 |
Location: | Italy | Status: | |
| I tried Office 2006 but upon installation on Sig3 it says device has wrong cpu code and don't install it.
How get around this? | |
| |
H/PC Philosopher Posts: | 471 |
Location: | Italy | Status: | |
| Problem worked out. It was due to a activesync connection problem but once installed it won't start on Sig3. No error, simply doesn't start.
One of you had this issue? | |
|
Seconds to generate: 0.171 - Cached queries : 64 - Executed queries : 9
| | |
|