Ok, I picked up the trial download of Pocket Quicken. It would not load with their installer so I found the CAB file for PPC2002 and copied to my storage card. I ran the CAB file and it installed in main memory. I tried running the program and it stated that there was missing libraries, so I copied all the libraries in the I found in the folder to the new folder created by the CAB file. I also put all the ARM dlls from cmonex's website in the same folder.
Hey according to all the other threads concerning PPC to HPC programs this is all you do.
I then tried to run the program. It starts, but any menus that I open are very small and in the upper left corner of the screen. They are not even regular PPC size.
I am very new at this. I have no idea what I just did in terms of the programs from cmonex
s site. I would like some direction with explaination, or a direction on where to start learning about the procedure. ie do I need to learn C, VB etc. or books on the general subject.
Just like it has been said, give a man a fish and you feed him for a day, but teach him to fish and you have fed him for a lifetime. I need taught or pointed in a direction on what to learn so I can be knowledgeable. Just saying drop an agyshell.dll in a program file does not help. I do not know what I just did if I just blindly follow those instructions.
I know there must have been many threads on this in the past, but searching is a fine art. So far I either get no hits or so many that it is hard to go through them all.
Thanks in advance