Quote
C:Amie - 2006-03-18 12:43 PM
In order to ActiveSync, first you have to setup a partnership with it. This cannot be achieved over Ethernet.
There are a number of guides and articles in the support section covering Windows CE and LAN access. The most prevalent one is going to be:
http://www.hpcfactor.com/support/cesd/c/0012.asp which is LAN sync.
However before you do that you need to perform a Personal Area sync. This article will give you some ideas over what you need to do that:
http://www.hpcfactor.com/qlink/?linkID=133
My version of ActiveSync
(4.1
) doesn't show a LAN connection as an option in Connection Settings. Perhaps I should go back to 3.8.
I got a register editor and followed the instructions at
http://www.hpcfactor.com/support/cesd/c/0027.asp. from the above link. However, there is no existing Partnership at the Windows CE Services so I'm stuck, not knowing enough to even think about creating one, an option that isn't explained at these pages.
Another question. Is there anywhere to find out where INBOX and IESAMPLE store mail, addresses and bookmarks? I'm sure they're in the flash ROM or some such place and not visible
(at least as far as I can tell
) so they could be copied to a CF card for safety in the event of a hard reset. I've tried using nPop as a mailer but it regularly freezes during downloads of email and so isn't reliable. I have Qmail as well, but I can't find any non-PhD instructions for configuring it.
Bob