G’day, Lads,
Here’s a question I’ve been wanting to ask for some time now about my never-ending quest to install a CE carputer in my vehicle. Per an
earlier post, we discovered that it is possible to install an external USB touch monitor on the Mobilepro 900/900c.
This thread may well become a benefit to the entire NEC community, and I hope it does. If not, I’ll be denied the dramatic reveal that I’ve built up in my mind
At any rate, I’m looking to increase the screen real estate of the VGA out on my 900c. We know it can be done in the Access viewer and in Conduits per
this intuitive hack What I’m shooting for is basically Nyditot on an external monitor. Primarily, a lot of smaller external monitors have 800 x 480 resolution
(much like screens on most TFT clamshells
). The goal here it to either Nyditot or directly registry hack
(the preferred method
) the STN screen that’s in the unit to 800 x 480 and then convince the Mobilepro that is should output at that resolution on an external monitor.
Could someone try this on their 900c or speculate as to the outcome? Is the above mentioned hack helpful towards this end in any way outside of Pocket Slides?
Edited by oflash 2006-10-19 3:25 PM