I finally got a V3 Linksys WPC11 for use with my PA2400w. Installed the official linksys CE 2.11 drivers, and the config utility sees my network, I've put in the correct SSID and it shows a great signal. It even says it's associated with my network. Unfortunately, not matter what I do I can't get an IP address.
I've tried using DHCP
(in the network control panel
), and also manually assigning an IP address + gateway, nothing works. IE will not open any web pages, stating that it can't find the IP address
(and when I'm using DHCP, CE itself will complain that it can't renew the IP after a few minutes
).
I've tried this on another wifi network with the exact same result. All security settings are OFF
(no wep
). When I pop in a wired ethernet card, DHCP and static IP work wonderfully.
I also tried the card in my laptop and it works beautifully, so it's not the card.
Any ideas? People say that the WPC11 v3 works fine with CE 2.11, I seem to be the only one with a problem. Maybe it's the Casio in particular? This is driving me nuts
Cheers