|
Factorite (Elite) Posts: | 192 |
Location: | Trenton, NJ | Status: | |
| Just downloaded a CE reg editor. Followed the steps. Still nothing. Begining to think I am cursed.
The only place I see the Lan card is under network.
Chris | |
| |
Administrator H/PC Oracle Posts: | 17,989 |
Location: | United Kingdom | Status: | |
| Can you get onto the Internet with the card, sync over serial and plese reinstall the NSP.
EDIT: Ignore that last part. You're using a H/PC Pro device. You should NOT have installed the CE 2.0 Networking update. If you have done. Remove it, but you may now need to Hard reset. | |
| |
Factorite (Elite) Posts: | 192 |
Location: | Trenton, NJ | Status: | |
| How do I remove it? I dont see it listed under Remove Programs.
Found it near the bottom. Said I removed it.?
Chris
Edited by ESCAPEMAX 2005-03-03 10:16 PM
| |
| |
Administrator H/PC Oracle Posts: | 17,989 |
Location: | United Kingdom | Status: | |
| "HPC Factor Handheld PC 2.0 Network SP" if you have installed it. | |
| |
Factorite (Elite) Posts: | 192 |
Location: | Trenton, NJ | Status: | |
| Its GONE..
Chris | |
| |
Administrator H/PC Oracle Posts: | 17,989 |
Location: | United Kingdom | Status: | |
| I suggest you ActiveSync backup the device from the host, hard reset. Test the adapter by just installing the PCMCIA update and the H/PC Pro (2.11) driver. If it works there then you know the activesync device image has been upset, if it doesn't then you need to trouble shoot further. | |
|
Seconds to generate: 0.171 - Cached queries : 64 - Executed queries : 8
| | |
|